#Miter spline jig plans full#
#Miter spline jig plans free#

Just using glue on a miter joint may result in breaks along the seams as the wood expands and contracts. Because it is a plastic glue will not stick to it and since it has a memory the tape tries to return to it original size and this makes yourВ joint even tighter. The spline jig I made is for strengthening mitered corners on picture frames and small boxes.

It is a plastic product and when stretched around theВ object it provides a cheap and a throw away clamp. A simple way that I do on complicated and simpleВ joints isВ a good roll of electricians tape. Glue the miters together and use either a band clamp or similar clamp to keep the joints tight. This is similar to that of a biscuit however much simpler to do and actually stronger. Using a framing square, check that the blade is 90-degrees to the tabletop and 90-degrees to the miter gauge sled. Your jig will likely have to be fine-tuned after its initial setup. The keyed miter is a variation of the splined joint that is both strong and. Both setting should be made to cause the slot to be cut near the center of the miter. Make a test joint before cutting into the material you plan on using for your enclosure. generally advisable to add reinforcement, usually with some sort of spline. You must cut all the corners with one setting and then reset the saw to cut at a 1/8' groove in a different location in the mitered piece. Workshop Woodworking Jigs Miter Spline Jig. this is the perfect jig for making beautiful spline joints in boxes. Looking for Something Search anything and hit enter. Highly detailed miter spline and dovetail key jig plans in 3d.

#Miter spline jig plans free#

THE Free Woodworking Plans and Projects Resource since 1998. Briefly, the steps go like this: cut and assemble the mitres, let them dry, run the mitre joints on end over a blade to produce the slots for the splines. Looking for Something Search anything and hit enter.

#Miter spline jig plans full#

The easiest and strongest mitered box is one that is held together with glue and a full length spline, These can be made using either a router table and a slotting bit and or a table saw with the blade set at 45 degrees passing the miter ends across the blade set to cut a shallow groove and passed by the blade two times cutting a 1/4 in groove. THE Free Woodworking Plans and Projects Resource since 1998.